I have a granuflo mixer that iam unable to transfer, new filter install, new transfer sensor install, but it jump from transfer to cycle complete can anyone help!

Check your float switch.

had the same problem.. changed out level sensor (with plug) Part # 150443. #83

After following one particular et, from clinic to clinic for awhile,check the nose of the transfer pump to see if there are any bits and pieces of the bag stuck in it.I would bet there lies your problem.Note, the pump is the same setup as the old naturalyte mixer motor.

Guest,

Did you get the problems before the installs, or after? Sometimes when you disconnect your wiring you get problems like this. Let us know an update please.

I had the same problem it turned out to be the transfer punp was clogged with plastic from the
granuflo bags

Yea mine went from "cycle complete" to "fill" on the rinse side all by itself. Other things too.
There's a new replacement sitting outside the door waiting to be installed.

you do realize they go through the rinse cycle 2 times

Yea, 2, 4 5 pick a number.

i just fixed mine...same problem it wouldnt transfer, it was the 3rd fuse... part # g15-024 from fresenius